Viewing file:  dma.c (6.96 KB) -rw-r--r--
Select action/file-type:
 (+) |  (+) |  (+) | Code (+) | Session (+) |  (+) | SDB (+) |  (+) |  (+) |  (+) |  (+) |  (+) |
/*
* carl9170 firmware - used by the ar9170 wireless device
*
* DMA descriptor handling functions
*
* Copyright (c) 2000-2005 ZyDAS Technology Corporation
* Copyright (c) 2007-2009 Atheros Communications, Inc.
* Copyright 2009 Johannes Berg <johannes@sipsolutions.net>
* Copyright 2009-2011 Christian Lamparter <chunkeey@googlemail.com>
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation; either version 2 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License along
* with this program; if not, write to the Free Software Foundation, Inc.,
* 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301 USA.
*/
#include "carl9170.h"
#include "wl.h"
#include "printf.h"
struct ar9170_dma_memory dma_mem __section(sram);
static void copy_dma_desc(struct dma_desc *dst,
struct dma_desc *src)
{
memcpy(dst, src, sizeof(struct dma_desc));
}
static void clear_descriptor(struct dma_desc *d)
{
d->status = AR9170_OWN_BITS_SW;
d->ctrl = 0;
d->dataSize = 0;
d->totalLen = 0;
d->lastAddr = d;
d->dataAddr = NULL;
d->nextAddr = d;
}
static void fill_descriptor(struct dma_desc *d, uint16_t size, uint8_t *data)
{
d->status = AR9170_OWN_BITS_SW;
d->ctrl = 0;
d->dataSize = size;
d->totalLen = 0;
d->lastAddr = d;
d->dataAddr = data;
d->nextAddr = NULL;
}
static void init_queue(struct dma_queue *q, struct dma_desc *d)
{
q->head = q->terminator = d;
}
/*
* - Init up_queue, down_queue, tx_queue[5], rx_queue.
* - Setup descriptors and data buffer address.
* - Ring descriptors rx_queue and down_queue by dma_reclaim().
*
* NOTE: LastAddr tempary point (same) to nextAddr after initialize.
* Because LastAddr is don't care in function dma_reclaim().
*/
void dma_init_descriptors(void)
{
unsigned int i, j;
for (i = 0; i < ARRAY_SIZE(dma_mem.terminator); i++)
clear_descriptor(&dma_mem.terminator[i]);
/* Assign terminators to DMA queues */
i = 0;
init_queue(&fw.pta.up_queue, &dma_mem.terminator[i++]);
init_queue(&fw.pta.down_queue, &dma_mem.terminator[i++]);
for (j = 0; j < __AR9170_NUM_TX_QUEUES; j++)
init_queue(&fw.wlan.tx_queue[j], &dma_mem.terminator[i++]);
init_queue(&fw.wlan.tx_retry, &dma_mem.terminator[i++]);
init_queue(&fw.wlan.rx_queue, &dma_mem.terminator[i++]);
fw.usb.int_desc = &dma_mem.terminator[i++];
fw.wlan.fw_desc = &dma_mem.terminator[i++];
#ifdef CONFIG_CARL9170FW_CAB_QUEUE
for (j = 0; j < CARL9170_INTF_NUM; j++)
init_queue(&fw.wlan.cab_queue[j], &dma_mem.terminator[i++]);
#endif /* CONFIG_CARL9170FW_CAB_QUEUE */
BUG_ON(AR9170_TERMINATOR_NUMBER != i);
DBG("Blocks:%d [tx:%d, rx:%d] Terminators:%d/%d\n",
AR9170_BLOCK_NUMBER, AR9170_TX_BLOCK_NUMBER,
AR9170_RX_BLOCK_NUMBER, AR9170_TERMINATOR_NUMBER, i);
/* Init descriptors and memory blocks */
for (i = 0; i < AR9170_BLOCK_NUMBER; i++) {
fill_descriptor(&dma_mem.block[i], AR9170_BLOCK_SIZE, dma_mem.data[i].data);
if (i < AR9170_TX_BLOCK_NUMBER)
dma_reclaim(&fw.pta.down_queue, &dma_mem.block[i]);
else
dma_reclaim(&fw.wlan.rx_queue, &dma_mem.block[i]);
}
/* Set DMA address registers */
set(AR9170_PTA_REG_DN_DMA_ADDRH, (uint32_t) fw.pta.down_queue.head >> 16);
set(AR9170_PTA_REG_DN_DMA_ADDRL, (uint32_t) fw.pta.down_queue.head & 0xffff);
set(AR9170_PTA_REG_UP_DMA_ADDRH, (uint32_t) fw.pta.up_queue.head >> 16);
set(AR9170_PTA_REG_UP_DMA_ADDRL, (uint32_t) fw.pta.up_queue.head & 0xffff);
for (i = 0; i < __AR9170_NUM_TX_QUEUES; i++)
set_wlan_txq_dma_addr(i, (uint32_t) fw.wlan.tx_queue[i].head);
set(AR9170_MAC_REG_DMA_RXQ_ADDR, (uint32_t) fw.wlan.rx_queue.head);
fw.usb.int_desc->dataSize = AR9170_BLOCK_SIZE;
fw.usb.int_desc->dataAddr = (void *) &dma_mem.reserved.rsp;
memset(DESC_PAYLOAD(fw.usb.int_desc), 0xff,
AR9170_INT_MAGIC_HEADER_SIZE);
memset(DESC_PAYLOAD_OFF(fw.usb.int_desc, AR9170_INT_MAGIC_HEADER_SIZE),
0, AR9170_BLOCK_SIZE - AR9170_INT_MAGIC_HEADER_SIZE);
/* rsp is now available for use */
fw.usb.int_desc_available = 1;
memset(DESC_PAYLOAD(fw.wlan.fw_desc), 0, 128);
fw.wlan.fw_desc_available = 1;
}
/*
* Free descriptor.
*
* Exchange the terminator and the first descriptor of the packet
* for hardware ascy...
*/
void dma_reclaim(struct dma_queue *q, struct dma_desc *desc)
{
struct dma_desc *tmpDesc, *last;
struct dma_desc tdesc;
/* 1. Set OWN bit to HW for all TDs to be added, clear ctrl and size */
tmpDesc = desc;
last = desc->lastAddr;
while (1) {
tmpDesc->status = AR9170_OWN_BITS_HW;
tmpDesc->ctrl = 0;
tmpDesc->totalLen = 0;
tmpDesc->dataSize = AR9170_BLOCK_SIZE;
/* TODO : Exception handle */
tmpDesc->lastAddr = tmpDesc;
if (tmpDesc == last)
break;
tmpDesc = tmpDesc->nextAddr;
}
/* 2. Next address of Last TD to be added = first TD */
tmpDesc->nextAddr = desc;
/* Link first TD to self */
desc->lastAddr = q->terminator;
/* 3. Copy first TD to be added to TTD */
copy_dma_desc(&tdesc, desc);
/* 4. Initialize new terminator */
clear_descriptor(desc);
/* 5. Copy TTD to last TD */
tdesc.status = 0;
copy_dma_desc((void *)q->terminator, (void *)&tdesc);
q->terminator->status |= AR9170_OWN_BITS_HW;
/* Update terminator pointer */
q->terminator = desc;
}
/*
* Put a complete packet into the tail of the Queue q.
* Exchange the terminator and the first descriptor of the packet
* for hardware ascy...
*/
void dma_put(struct dma_queue *q, struct dma_desc *desc)
{
struct dma_desc *tmpDesc;
struct dma_desc tdesc;
tmpDesc = desc;
while (1) {
/* update totalLen */
tmpDesc->totalLen = desc->totalLen;
/* 1. Set OWN bit to HW for all TDs to be added */
tmpDesc->status = AR9170_OWN_BITS_HW;
/* TODO : Exception handle */
tmpDesc->lastAddr = desc->lastAddr;
if (desc->lastAddr == tmpDesc)
break;
tmpDesc = tmpDesc->nextAddr;
}
/* 2. Next address of Last TD to be added = first TD */
desc->lastAddr->nextAddr = desc;
/* If there is only one descriptor, update pointer of last descriptor */
if (desc->lastAddr == desc)
desc->lastAddr = q->terminator;
/* 3. Copy first TD to be added to TTD */
copy_dma_desc(&tdesc, desc);
/* 4. Initialize new terminator */
clear_descriptor(desc);
/* 5. Copy TTD to last TD */
tdesc.status &= (~AR9170_OWN_BITS);
copy_dma_desc((void *)q->terminator, (void *)&tdesc);
q->terminator->status |= AR9170_OWN_BITS_HW;
/* Update terminator pointer */
q->terminator = desc;
}
struct dma_desc *dma_unlink_head(struct dma_queue *queue)
{
struct dma_desc *desc;
if (queue_empty(queue))
return NULL;
desc = queue->head;
queue->head = desc->lastAddr->nextAddr;
/* poison nextAddr address */
desc->lastAddr->nextAddr = desc->lastAddr;
desc->lastAddr->lastAddr = desc->lastAddr;
return desc;
}
|