Viewing file:  jazzdma.h (2.93 KB) -rw-r--r--
Select action/file-type:
 (+) |  (+) |  (+) | Code (+) | Session (+) |  (+) | SDB (+) |  (+) |  (+) |  (+) |  (+) |  (+) |
/*
* Helpfile for jazzdma.c -- Mips Jazz R4030 DMA controller support
*/
#ifndef _ASM_JAZZDMA_H
#define _ASM_JAZZDMA_H
/*
* Prototypes and macros
*/
extern unsigned long vdma_alloc(unsigned long paddr, unsigned long size);
extern int vdma_free(unsigned long laddr);
extern int vdma_remap(unsigned long laddr, unsigned long paddr,
unsigned long size);
extern unsigned long vdma_phys2log(unsigned long paddr);
extern unsigned long vdma_log2phys(unsigned long laddr);
extern void vdma_stats(void); /* for debugging only */
extern void vdma_enable(int channel);
extern void vdma_disable(int channel);
extern void vdma_set_mode(int channel, int mode);
extern void vdma_set_addr(int channel, long addr);
extern void vdma_set_count(int channel, int count);
extern int vdma_get_residue(int channel);
extern int vdma_get_enable(int channel);
/*
* some definitions used by the driver functions
*/
#define VDMA_PAGESIZE 4096
#define VDMA_PGTBL_ENTRIES 4096
#define VDMA_PGTBL_SIZE (sizeof(VDMA_PGTBL_ENTRY) * VDMA_PGTBL_ENTRIES)
#define VDMA_PAGE_EMPTY 0xff000000
/*
* Macros to get page no. and offset of a given address
* Note that VDMA_PAGE() works for physical addresses only
*/
#define VDMA_PAGE(a) ((unsigned int)(a) >> 12)
#define VDMA_OFFSET(a) ((unsigned int)(a) & (VDMA_PAGESIZE-1))
/*
* error code returned by vdma_alloc()
* (See also arch/mips/kernel/jazzdma.c)
*/
#define VDMA_ERROR 0xffffffff
/*
* VDMA pagetable entry description
*/
typedef volatile struct VDMA_PGTBL_ENTRY {
unsigned int frame; /* physical frame no. */
unsigned int owner; /* owner of this entry (0=free) */
} VDMA_PGTBL_ENTRY;
/*
* DMA channel control registers
* in the R4030 MCT_ADR chip
*/
#define JAZZ_R4030_CHNL_MODE 0xE0000100 /* 8 DMA Channel Mode Registers, */
/* 0xE0000100,120,140... */
#define JAZZ_R4030_CHNL_ENABLE 0xE0000108 /* 8 DMA Channel Enable Regs, */
/* 0xE0000108,128,148... */
#define JAZZ_R4030_CHNL_COUNT 0xE0000110 /* 8 DMA Channel Byte Cnt Regs, */
/* 0xE0000110,130,150... */
#define JAZZ_R4030_CHNL_ADDR 0xE0000118 /* 8 DMA Channel Address Regs, */
/* 0xE0000118,138,158... */
/* channel enable register bits */
#define R4030_CHNL_ENABLE (1<<0)
#define R4030_CHNL_WRITE (1<<1)
#define R4030_TC_INTR (1<<8)
#define R4030_MEM_INTR (1<<9)
#define R4030_ADDR_INTR (1<<10)
/*
* Channel mode register bits
*/
#define R4030_MODE_ATIME_40 (0) /* device access time on remote bus */
#define R4030_MODE_ATIME_80 (1)
#define R4030_MODE_ATIME_120 (2)
#define R4030_MODE_ATIME_160 (3)
#define R4030_MODE_ATIME_200 (4)
#define R4030_MODE_ATIME_240 (5)
#define R4030_MODE_ATIME_280 (6)
#define R4030_MODE_ATIME_320 (7)
#define R4030_MODE_WIDTH_8 (1<<3) /* device data bus width */
#define R4030_MODE_WIDTH_16 (2<<3)
#define R4030_MODE_WIDTH_32 (3<<3)
#define R4030_MODE_INTR_EN (1<<5)
#define R4030_MODE_BURST (1<<6) /* Rev. 2 only */
#define R4030_MODE_FAST_ACK (1<<7) /* Rev. 2 only */
#endif /* _ASM_JAZZDMA_H */
|