Viewing file:  mce.h (7.68 KB) -rw-r--r--
Select action/file-type:
 (+) |  (+) |  (+) | Code (+) | Session (+) |  (+) | SDB (+) |  (+) |  (+) |  (+) |  (+) |  (+) |
#ifndef _ASM_X86_MCE_H
#define _ASM_X86_MCE_H
#include <uapi/asm/mce.h>
/*
* Machine Check support for x86
*/
/* MCG_CAP register defines */
#define MCG_BANKCNT_MASK 0xff /* Number of Banks */
#define MCG_CTL_P (1ULL<<8) /* MCG_CTL register available */
#define MCG_EXT_P (1ULL<<9) /* Extended registers available */
#define MCG_CMCI_P (1ULL<<10) /* CMCI supported */
#define MCG_EXT_CNT_MASK 0xff0000 /* Number of Extended registers */
#define MCG_EXT_CNT_SHIFT 16
#define MCG_EXT_CNT(c) (((c) & MCG_EXT_CNT_MASK) >> MCG_EXT_CNT_SHIFT)
#define MCG_SER_P (1ULL<<24) /* MCA recovery/new status bits */
#define MCG_ELOG_P (1ULL<<26) /* Extended error log supported */
/* MCG_STATUS register defines */
#define MCG_STATUS_RIPV (1ULL<<0) /* restart ip valid */
#define MCG_STATUS_EIPV (1ULL<<1) /* ip points to correct instruction */
#define MCG_STATUS_MCIP (1ULL<<2) /* machine check in progress */
/* MCi_STATUS register defines */
#define MCI_STATUS_VAL (1ULL<<63) /* valid error */
#define MCI_STATUS_OVER (1ULL<<62) /* previous errors lost */
#define MCI_STATUS_UC (1ULL<<61) /* uncorrected error */
#define MCI_STATUS_EN (1ULL<<60) /* error enabled */
#define MCI_STATUS_MISCV (1ULL<<59) /* misc error reg. valid */
#define MCI_STATUS_ADDRV (1ULL<<58) /* addr reg. valid */
#define MCI_STATUS_PCC (1ULL<<57) /* processor context corrupt */
#define MCI_STATUS_S (1ULL<<56) /* Signaled machine check */
#define MCI_STATUS_AR (1ULL<<55) /* Action required */
/*
* Note that the full MCACOD field of IA32_MCi_STATUS MSR is
* bits 15:0. But bit 12 is the 'F' bit, defined for corrected
* errors to indicate that errors are being filtered by hardware.
* We should mask out bit 12 when looking for specific signatures
* of uncorrected errors - so the F bit is deliberately skipped
* in this #define.
*/
#define MCACOD 0xefff /* MCA Error Code */
/* Architecturally defined codes from SDM Vol. 3B Chapter 15 */
#define MCACOD_SCRUB 0x00C0 /* 0xC0-0xCF Memory Scrubbing */
#define MCACOD_SCRUBMSK 0xeff0 /* Skip bit 12 ('F' bit) */
#define MCACOD_L3WB 0x017A /* L3 Explicit Writeback */
#define MCACOD_DATA 0x0134 /* Data Load */
#define MCACOD_INSTR 0x0150 /* Instruction Fetch */
/* MCi_MISC register defines */
#define MCI_MISC_ADDR_LSB(m) ((m) & 0x3f)
#define MCI_MISC_ADDR_MODE(m) (((m) >> 6) & 7)
#define MCI_MISC_ADDR_SEGOFF 0 /* segment offset */
#define MCI_MISC_ADDR_LINEAR 1 /* linear address */
#define MCI_MISC_ADDR_PHYS 2 /* physical address */
#define MCI_MISC_ADDR_MEM 3 /* memory address */
#define MCI_MISC_ADDR_GENERIC 7 /* generic */
/* CTL2 register defines */
#define MCI_CTL2_CMCI_EN (1ULL << 30)
#define MCI_CTL2_CMCI_THRESHOLD_MASK 0x7fffULL
#define MCJ_CTX_MASK 3
#define MCJ_CTX(flags) ((flags) & MCJ_CTX_MASK)
#define MCJ_CTX_RANDOM 0 /* inject context: random */
#define MCJ_CTX_PROCESS 0x1 /* inject context: process */
#define MCJ_CTX_IRQ 0x2 /* inject context: IRQ */
#define MCJ_NMI_BROADCAST 0x4 /* do NMI broadcasting */
#define MCJ_EXCEPTION 0x8 /* raise as exception */
#define MCJ_IRQ_BROADCAST 0x10 /* do IRQ broadcasting */
#define MCE_OVERFLOW 0 /* bit 0 in flags means overflow */
/* Software defined banks */
#define MCE_EXTENDED_BANK 128
#define MCE_THERMAL_BANK (MCE_EXTENDED_BANK + 0)
#define K8_MCE_THRESHOLD_BASE (MCE_EXTENDED_BANK + 1)
#define MCE_LOG_LEN 32
#define MCE_LOG_SIGNATURE "MACHINECHECK"
/*
* This structure contains all data related to the MCE log. Also
* carries a signature to make it easier to find from external
* debugging tools. Each entry is only valid when its finished flag
* is set.
*/
struct mce_log {
char signature[12]; /* "MACHINECHECK" */
unsigned len; /* = MCE_LOG_LEN */
unsigned next;
unsigned flags;
unsigned recordlen; /* length of struct mce */
struct mce entry[MCE_LOG_LEN];
};
struct mca_config {
bool dont_log_ce;
bool cmci_disabled;
bool ignore_ce;
bool disabled;
bool ser;
bool bios_cmci_threshold;
u8 banks;
s8 bootlog;
int tolerant;
int monarch_timeout;
int panic_timeout;
u32 rip_msr;
};
extern struct mca_config mca_cfg;
extern void mce_register_decode_chain(struct notifier_block *nb);
extern void mce_unregister_decode_chain(struct notifier_block *nb);
#include <linux/percpu.h>
#include <linux/init.h>
#include <linux/atomic.h>
extern int mce_p5_enabled;
#ifdef CONFIG_X86_MCE
int mcheck_init(void);
void mcheck_cpu_init(struct cpuinfo_x86 *c);
#else
static inline int mcheck_init(void) { return 0; }
static inline void mcheck_cpu_init(struct cpuinfo_x86 *c) {}
#endif
#ifdef CONFIG_X86_ANCIENT_MCE
void intel_p5_mcheck_init(struct cpuinfo_x86 *c);
void winchip_mcheck_init(struct cpuinfo_x86 *c);
static inline void enable_p5_mce(void) { mce_p5_enabled = 1; }
#else
static inline void intel_p5_mcheck_init(struct cpuinfo_x86 *c) {}
static inline void winchip_mcheck_init(struct cpuinfo_x86 *c) {}
static inline void enable_p5_mce(void) {}
#endif
void mce_setup(struct mce *m);
void mce_log(struct mce *m);
DECLARE_PER_CPU(struct device *, mce_device);
/*
* Maximum banks number.
* This is the limit of the current register layout on
* Intel CPUs.
*/
#define MAX_NR_BANKS 32
#ifdef CONFIG_X86_MCE_INTEL
void mce_intel_feature_init(struct cpuinfo_x86 *c);
void cmci_clear(void);
void cmci_reenable(void);
void cmci_rediscover(void);
void cmci_recheck(void);
#else
static inline void mce_intel_feature_init(struct cpuinfo_x86 *c) { }
static inline void cmci_clear(void) {}
static inline void cmci_reenable(void) {}
static inline void cmci_rediscover(void) {}
static inline void cmci_recheck(void) {}
#endif
#ifdef CONFIG_X86_MCE_AMD
void mce_amd_feature_init(struct cpuinfo_x86 *c);
#else
static inline void mce_amd_feature_init(struct cpuinfo_x86 *c) { }
#endif
int mce_available(struct cpuinfo_x86 *c);
DECLARE_PER_CPU(unsigned, mce_exception_count);
DECLARE_PER_CPU(unsigned, mce_poll_count);
extern atomic_t mce_entry;
typedef DECLARE_BITMAP(mce_banks_t, MAX_NR_BANKS);
DECLARE_PER_CPU(mce_banks_t, mce_poll_banks);
enum mcp_flags {
MCP_TIMESTAMP = (1 << 0), /* log time stamp */
MCP_UC = (1 << 1), /* log uncorrected errors */
MCP_DONTLOG = (1 << 2), /* only clear, don't log */
};
void machine_check_poll(enum mcp_flags flags, mce_banks_t *b);
int mce_notify_irq(void);
void mce_notify_process(void);
DECLARE_PER_CPU(struct mce, injectm);
extern void register_mce_write_callback(ssize_t (*)(struct file *filp,
const char __user *ubuf,
size_t usize, loff_t *off));
/* Disable CMCI/polling for MCA bank claimed by firmware */
extern void mce_disable_bank(int bank);
/*
* Exception handler
*/
/* Call the installed machine check handler for this CPU setup. */
extern void (*machine_check_vector)(struct pt_regs *, long error_code);
void do_machine_check(struct pt_regs *, long);
/*
* Threshold handler
*/
extern void (*mce_threshold_vector)(void);
extern void (*threshold_cpu_callback)(unsigned long action, unsigned int cpu);
/*
* Thermal handler
*/
void intel_init_thermal(struct cpuinfo_x86 *c);
void mce_log_therm_throt_event(__u64 status);
/* Interrupt Handler for core thermal thresholds */
extern int (*platform_thermal_notify)(__u64 msr_val);
/* Interrupt Handler for package thermal thresholds */
extern int (*platform_thermal_package_notify)(__u64 msr_val);
/* Callback support of rate control, return true, if
* callback has rate control */
extern bool (*platform_thermal_package_rate_control)(void);
#ifdef CONFIG_X86_THERMAL_VECTOR
extern void mcheck_intel_therm_init(void);
#else
static inline void mcheck_intel_therm_init(void) { }
#endif
/*
* Used by APEI to report memory error via /dev/mcelog
*/
struct cper_sec_mem_err;
extern void apei_mce_report_mem_error(int corrected,
struct cper_sec_mem_err *mem_err);
#endif /* _ASM_X86_MCE_H */
|